Plug the drive into the wall via the included power adapter, and. Have a look at the link below and let me know if that helps or you need anything further. Connect your network drive to your router Most drives should offer some instructions, but generally the process is the same. I've now written a whole guide on plex permissions, which can get into quite a complex topic but I've tried to keep it as simple as possible.
#Synology network disk map password
Once your disk drives appear, click on the first one you see and then click on 'Map Network Drive.' You should input the username and password that you created for your user earlier under the right group policy. So, on your NAS (and in a console) type in 'sudo chmod -Rv 764 yoursharedirectory'. This process will show you the latest IP of your SYNOLOGY disk drives. That way, you could omit the password altogether. If you want to go down that route, here's an example of one of my NFS lines in my fstab in case it helps:ġ92.168.43.15:Video /mnt/Video nfs rw,hard,intr 0 0Īnother option for you is to use the chmod command and make sure that read only is set to everyone. Basically NFS is less CPU intensive and works better between *NIX systems anyway. Given you are being prompted for a password, this is likely the sticking point, or at least the first sticking point to begin addressing fault finding - (the second one will be just making sure that the files and directories have appropriate access).īefore I say anything further though, I've personally found NFS to be much more reliable and simpler to set up. Switch between Turn on password protected sharing and Turn off password protected sharing. All Plex does is look at the folders presented to the local linux machine as the active Plex user, which by default is the user 'plex'. Open Start > Settings > Network & Internet > Status. SMB version 3 is much preferred but not always available by the client (MAC users be ware).As you have probably figured out, this has very little to do with Plex. And be sure to use SMB version 2 or higher. Instead, connect to a NAS with user privileges. Lastly, most experts will tell you never to connect to a NAS through SMB with admin user privileges. I always have separate user names for each device and require "Connect with different credentials" to be checked.
#Synology network disk map Pc
(I think) that will only work if your PC user name and password are identical to a user name and password for your NAS. When you see a confirmation message, click Connect. I also noticed that image #2 shows "Connect with different credentials" unchecked. Enter 'smb://' and the hostname or IP address of the Synology NAS.
If you are allowing your NAS to sleep and you have not assigned a static IP of your NAS in your router, then the DHCP assignment might refresh and your NAS gets a new LAN IP address. This same issue works in the other direction. And the next time you boot (or wake), your NAS may not be able to see it. If not, you run the risk of your PC getting assigned a different LAN IP with your router's DHCP server. In addition, I strongly recommend you assign a static IP for your PC in your router.
Each have mapped drives to multiple NAS Shared folders Wait for the unit to complete its boot sequence.Have 2 PCs running Win11 with SMB connections to my DS- 220+ without issue.
0 kommentar(er)
